5500B MCF Plating System
- Monolithic Crystal Filter final frequency adjust plating system
- Plates FE1, FE2 and bandwidth touser specified targets
- Measured parameters are checked against easy to define Q.C. limits after each filter is plated
- Measurement data may immediately be stored and/or printed
- Leaded devices held in linear transports
- Surface mount devices held in component tray or customer specified pallet array
- The component area is customized to precise device size requirements
- Proprietary measurement technique
- Does not require a variable inductor
- Precise X-Y table positioning
SPECIFICATIONS
| Frequency Range: | 10 MHz to 300 MHz |
| Plating Performance: | ± 4 ppm typical final frequency |
MEASUREMENTS
- Center Frequency
- Symmetry
- Short Circuit Bandwidth
- Resonator Frequency Port 1
- Resonator Frequency Port 2
- Total Resistance
- Resonator 1
Resistance, Inductance, Capacitance - Resonator 2
Resistance, Inductance, Capacitance
SYSTEM CONFIGURATION
- Vector Voltmeter
- Dual Output Synthesizers
- X-Y Table Vacuum Assembly
- Turbo or Cryo Pump
- Direct Drive Roughing Pump
- Computer
- Light Pole
- System Software
- Closed Loop Water Cooled Filament
- Bar Code Reader (Optional)
- Printer (Optional)
- Quartz Crystal Plating (Optional)
FACILITY REQUIREMENTS
| Power: | 220 Volts @ 30 A or 380 Volts @ 20 A, 3-Phase |
| Inlet Pressures: Air: Nitrogen: |
150 PSIG Maximum 90 PSIG 20 PSIG (Turbo), 70 PSIG (cryo) |
| Cryo Water Cooling: | 0.5 GPM @ 70° F, typical |
| Dimensions: | 52.5 x 34.5 x 55 Inches (excluding light pole & cryocompressor) (133.4 x 87.6 x 139.7cm) Cryo pump compressor 19.5 x 24 x 19 inches (49.2 x 61 x 48.3 cm) Light pole 39.5 inches (100.3 cm) |